Home » Sponsored » Pi Speakers » making freq. response graph
Re: making freq. response graph [message #41775 is a reply to message #41774] Tue, 01 July 2003 15:37 Go to previous message
Wayne Parham is currently offline  Wayne Parham
Messages: 18792
Registered: January 2001
Illuminati (33rd Degree)

You're right that if you want to have an automatic process then you'll need a mechanism that synchronizes the generator sweep with the measurement device. You could have your computer D/A generate the sweep and read it with its A/D. Then synchronization would be a matter of timing logic in your code. Alternately, if your signal generator has some sort of synchronization signal, perhaps you could read it programmatically. Either way, you'll need to have a mechanism in place.

 
Read Message
Read Message
Read Message
Read Message
Previous Topic: 511B update #3 Major Improvement!
Next Topic: Low distortion op-amp
Goto Forum:
  


Current Time: Wed Dec 04 21:30:06 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest