AudioRoundTable.com: Pi Speakers

Home » Sponsored » Pi Speakers » Eminence horn

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

1kHz crossover values [message #41468 is a reply to message #41467]

Fri, 23 May 2003 15:28

Wayne Parham
Messages: 18727
Registered: January 2001

Illuminati (33rd Degree)

The values for an eight ohm 1kHz crossover are shown in the post called "Pi Speakers Crossover" and its response is shown on the post called "Pi Speakers Crossover SPICE values." Sorry, but I haven't done one for a 16 ohm circuit. It would be very easy to do in Spice though. Modify the values for R1, R2 and C1 to set the Q and get the response curve you want. Make it look just like Adrian's from the post above and you're set!

Report message to a moderator

[Message index]

		Eminence horn By: LuxmanLover on Thu, 22 May 2003 15:01
		Damping and crossover filter Q By: Wayne Parham on Thu, 22 May 2003 16:15
		Re: Damping and crossover filter Q (or lost in Saskatoon) By: LuxmanLover on Thu, 22 May 2003 16:38
		Use of a horn under Fc By: Wayne Parham on Thu, 22 May 2003 20:53
		Re: pull the h290's By: Sam P. on Fri, 23 May 2003 04:49
		Re: pull the h290's By: LuxmanLover on Fri, 23 May 2003 05:36
		Re: why not x at 1kHz?nt By: Sam P. on Fri, 23 May 2003 08:26
		Re: why not x at 1kHz?nt By: LuxmanLover on Fri, 23 May 2003 14:31
		1kHz crossover values By: Wayne Parham on Fri, 23 May 2003 15:28

Previous Topic:	crossover doc
Next Topic:	JBL vs. Lambda??

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Jul 19 08:15:08 CDT 2024