AudioRoundTable.com: Pi Speakers » Question for those building Steve bench's tube crossover

Home » Sponsored » Pi Speakers » Question for those building Steve bench's tube crossover

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Question for those building Steve bench's tube crossover [message #40026 is a reply to message #40024]

Thu, 23 January 2003 10:57

Sam P.
Messages: 307
Registered: May 2009

Grand Master

put your email up and I can scan an image to you. Just a redraw of the Eico HFT-94 AM tuner power supply. 6X4 full wave rectifier tube, and a cap input RC filter. Those 6DJ8's are running class A, and won't vary their current draw much during normal operation, so once you get a standard unregulated power supply "dialed in" it will hold the B+ steady anyway. I went with Solen polycaps for the 40,20, and 20uF caps needed. Let me know if you need it.
.
DC filament supply is straight from the ratshack book, using a 7806 3 term. regulator gives a clean 5.95vDC output. HEATSINK mandatory.
.
Hum problems were recently mentioned regarding this circuit, BTW...Sam

Report message to a moderator

[Message index]

		Question for those building Steve bench's tube crossover By: Garland on Thu, 23 January 2003 09:38
		Re: Question for those building Steve bench's tube crossover By: EZ_Angus on Thu, 23 January 2003 10:31
		Re: Question for those building Steve bench's tube crossover By: Sam P. on Thu, 23 January 2003 10:57
		Re: Question for those building Steve bench's tube crossover By: Rusty Iron on Fri, 24 January 2003 05:03
		p/s and circuits in same chassis? By: Sam P. on Fri, 24 January 2003 05:27
		Thanks, guys! By: Garland on Fri, 24 January 2003 05:26

Previous Topic:	Hey Wayne! Didn't Nelson Faraday invent Baseball? (Way too long)
Next Topic:	2Pi port

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Jul 12 21:49:44 CDT 2024