Home » Sponsored » Pi Speakers » "phase loaded" woofer circa 1950's
"phase loaded" woofer circa 1950's [message #39481] Sat, 14 December 2002 15:57 Go to previous message
Sam P. is currently offline  Sam P.
Messages: 307
Registered: May 2009
Grand Master
is shaking my LR apart! EV designed (well, maybe PWK) a system where the woofer faced the wall, and was in a sealed enclosure. Made for the bottom octave up to 300Hz.

So I took a EV 15 BWK woofer, put it in a spare 8 cu.ft./40Hz. jbl enclosure, and faced it towards the wall (about 6 inches away), near the only room corner. Driven by one of the LM 1875's in my pos dolby decoder/amp...AWESOME DEEP POWERFULL GUT SHAKING...can't wait for "The Lord of the Rings" movie in a few minutes. All bass boost "off", and the thing is going SO LOW. So now you all know what to do with your "coffee table"/jbl 4508's now. Sam

happy coincidence...an old Eico unbuilt kit I had has EXACTLY the right power tranny for building a 150 vDC tube rectified (mullard 6X4) power supply for the Pi-TAX. i'm wondering about reworking Steve's circuit to allow using 12AU7's, then the whole thing would be nos brit tubes, FWIW. Sam

 
Read Message
Read Message
Previous Topic: corner horns
Next Topic: Progress Report: This is Fun!
Goto Forum:
  


Current Time: Fri Nov 29 22:22:34 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest