AudioRoundTable.com: Pi Speakers » delta 12LF goes high enough?

Home » Sponsored » Pi Speakers » delta 12LF goes high enough?

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

delta 12LF goes high enough? [message #38501]

Mon, 30 September 2002 12:33

bqc
Messages: 26
Registered: May 2009

Chancellor

to be used with ksn 1038? Eminence frequency plots shows sensitivity
down to 92 db at 3.5 KHZ. And it looks like KSN 1038 starts picking up
also at around 3.5 kHZ. Is this a good combination for stage monitor
in a 1 cubic foot box? Or should I use a Kappa 12 or delta pro 12
instead?

Report message to a moderator

Re: delta 12LF goes high enough? [message #38502 is a reply to message #38501]

Mon, 30 September 2002 12:50

Wayne Parham
Messages: 18789
Registered: January 2001

Illuminati (33rd Degree)

I am sometimes questioned about the performance of large format drivers above 1kHz, but I rarely get asked about their performance at 3kHz. I suspect that on-axis, it will sound alright, something like a full-range driver. But the "LF" versions rarely perform well at higher frequencies and the Delta 12LF is something of an exception. Let us know how it sounds if you decide to do it.

Report message to a moderator

Re: delta 12LF goes high enough? [message #38503 is a reply to message #38502]

Mon, 30 September 2002 13:42

bqc
Messages: 26
Registered: May 2009

Chancellor

Thanks Wayne
So you are saying the Delta 12LF is an exception to the rule that
LF driver dont perform well at higher frequencies? Which means that
it would do ok?

I heard people talked about driver break up mode and how it is unpleasant
to listen to. Does driver break up mode usually happen at the
high end of its frequency range? If so then how can one
use the the Alpha 10 in the Studio 2pi's all the way up to its upper range without hearing any of the break up mode?

Report message to a moderator

Re: delta 12LF goes high enough? [message #38507 is a reply to message #38503]

Mon, 30 September 2002 14:56

Wayne Parham
Messages: 18789
Registered: January 2001

Illuminati (33rd Degree)

"Break-up modes" are frequencies where the cone twists and has ripples across its surface instead of moving as a rigid piston in a single, unified motion. Some speakers get very loud and harsh in the breakup region, others are pretty controlled. Some designers try to avoid using the speaker in this mode for technical reasons, but others use the increased output to their advantage. Single driver designs, especially those with whizzer cones are an example of purpose-designed use of controlled breakup mode behavior.

Report message to a moderator

Previous Topic:	4Pi Pro crossover
Next Topic:	Wayne: Best Pi for Decware Zen Amp?

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Nov 29 04:35:03 CST 2024