AudioRoundTable.com: Pi Speakers

Home » Sponsored » Pi Speakers » 4Pi Pro crossover

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: 4Pi Pro crossover [message #38474 is a reply to message #38471]

Sat, 28 September 2002 12:44

Wayne Parham
Messages: 18790
Registered: January 2001

Illuminati (33rd Degree)

Actually, you can't really "overkill" so the large wire for the woofer is fine, but you don't really need to go bigger than 16 guage for this coil, even if it has an air coil. The required coil in the tweeter circuit is a bit surprising, because there actually is the potential for a reasonably high current through this coil. But 20 guage is fine there.

Report message to a moderator

[Message index]

		4Pi Pro crossover By: LuxmanLover on Sat, 28 September 2002 11:34
		Re: 4Pi Pro crossover By: Wayne Parham on Sat, 28 September 2002 12:44
		Re: 4Pi Pro crossover By: LuxmanLover on Sat, 28 September 2002 13:34
		Re: 4Pi Pro crossover By: Wayne Parham on Sat, 28 September 2002 13:38
		Should I use ..... By: LuxmanLover on Sat, 28 September 2002 14:41
		Re: Should I use ..... By: Wayne Parham on Sat, 28 September 2002 16:09
		Thx again wayne...nt By: LuxmanLover on Sat, 28 September 2002 16:15
		Sigh!!!!! By: LuxmanLover on Mon, 30 September 2002 11:08

Previous Topic:	Will mounted 2426 fit through horn hole?
Next Topic:	delta 12LF goes high enough?

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Nov 29 10:26:22 CST 2024