AudioRoundTable.com: Pi Speakers

Home » Sponsored » Pi Speakers » 4Pi Pro crossover

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

4Pi Pro crossover [message #38471]

Sat, 28 September 2002 11:34

LuxmanLover
Messages: 164
Registered: May 2009

Master

What gauge wire is required for the inductors in the 4Pi Pro. I've been attempting to wind my own with mixed results, in other words, I'm about ready to throw in the towel and phone Solen! I was wondering if 20 gauge on the tweeter and 12 gauge on the woofer would suffice. Underkill, overkill?
Kelly

Report message to a moderator

[Message index]

		4Pi Pro crossover By: LuxmanLover on Sat, 28 September 2002 11:34
		Re: 4Pi Pro crossover By: Wayne Parham on Sat, 28 September 2002 12:44
		Re: 4Pi Pro crossover By: LuxmanLover on Sat, 28 September 2002 13:34
		Re: 4Pi Pro crossover By: Wayne Parham on Sat, 28 September 2002 13:38
		Should I use ..... By: LuxmanLover on Sat, 28 September 2002 14:41
		Re: Should I use ..... By: Wayne Parham on Sat, 28 September 2002 16:09
		Thx again wayne...nt By: LuxmanLover on Sat, 28 September 2002 16:15
		Sigh!!!!! By: LuxmanLover on Mon, 30 September 2002 11:08

Previous Topic:	Will mounted 2426 fit through horn hole?
Next Topic:	delta 12LF goes high enough?

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Dec 01 13:12:59 CST 2024