Home » Sponsored » Pi Speakers » Port Size 4-pi
Port Size 4-pi [message #38065] Tue, 27 August 2002 07:19 Go to next message
JBLman is currently offline  JBLman
Messages: 12
Registered: May 2009
Chancellor
The sketch prints for this speaker show a port sze of 3 1/2" x 6". I assume this is outside diameter and that the port is usually constructed of 3/4 in plywood. So it it the intent to have an inside diameter of 2" x 4 1/2" with a cross section of 9 square inches?
Re: Port Size 4-pi [message #38071 is a reply to message #38065] Tue, 27 August 2002 11:55 Go to previous messageGo to next message
Wayne Parham is currently offline  Wayne Parham
Messages: 18726
Registered: January 2001
Illuminati (33rd Degree)

The dimensions shown for the port are inside dimensions. The port is to be 3.5" x 6" and 10" long.

Re: Port Size 4-pi [message #38075 is a reply to message #38071] Tue, 27 August 2002 12:16 Go to previous messageGo to next message
JBLman is currently offline  JBLman
Messages: 12
Registered: May 2009
Chancellor
Thanks, good thing I asked: From the plans I interpreted all the other measurments to be outside diameter. Was that right in terms of H x W x D ?
Re: Port Size 4-pi [message #38078 is a reply to message #38075] Tue, 27 August 2002 12:27 Go to previous message
Wayne Parham is currently offline  Wayne Parham
Messages: 18726
Registered: January 2001
Illuminati (33rd Degree)

That's right - All measurements are outside dimensions except those of the port, which show the size of the duct height, width and depth.

Previous Topic: Pi Subwoofer cabinet
Next Topic: Are Pi Speakers Suited For Nearfield Listening?
Goto Forum:
  


Current Time: Wed Jul 17 02:44:24 CDT 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest