AudioRoundTable.com: Pi Speakers

Home » Sponsored » Pi Speakers » Crossover network

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Crossover network [message #37801]

Thu, 15 August 2002 04:05

ozzi
Messages: 43
Registered: May 2009

Baron

Any chance of posting a picture of the complete crossover network for the theatre4 pi??

Report message to a moderator

Re: Crossover network [message #37803 is a reply to message #37801]

Thu, 15 August 2002 05:57

Wayne Parham
Messages: 18792
Registered: January 2001

Illuminati (33rd Degree)

There are photos of the compensation network cable assemblies in the post called "Compensation networks - Photos". I expected I could find a photo of the "base unit," which is the Eminence PXBII1K6 crossover, but surprisingly, I couldn't. You can find photos of a couple of their offerings, but not that particular crossover. So one of these times soon, I'll do exactly as you've suggested, and put a photo of the PXBII1K6 online.

Also, Brendon (Super_BQ) has a photo of the crossover on his web page at www.geocities.com/super_bq/4Pi.html. Brendon chose to wire his network completely from individual components rather than to use the printed circuit board. Some do this so they can "hand pick" the components used.

Report message to a moderator

Wayne's top picture [message #37804 is a reply to message #37803]

Thu, 15 August 2002 06:12

ozzi
Messages: 43
Registered: May 2009

Baron

Am I correct if I say your top picture has two of the same component (from different angles) and that only one should be used??

Please excuse the ignorance, it is knock off time in South Africa??

Cheers
Oscar

Report message to a moderator

Am I also correct to say that.......... [message #37805 is a reply to message #37804]

Thu, 15 August 2002 06:19

ozzi
Messages: 43
Registered: May 2009

Baron

......the spade plugs connected to the flexwire connects to the speaker components and the ones closest to the network connects to the crossover board??

Thanks
Oscar

Report message to a moderator