AudioRoundTable.com: Pi Speakers » Building a pair of 2 Pi in solid pine?

Home » Sponsored » Pi Speakers » Building a pair of 2 Pi in solid pine?

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Tolerance [message #37312 is a reply to message #37302]

Mon, 15 July 2002 10:04

Erik Johansson
Messages: 65
Registered: May 2009

Viscount

Here is a picture of the ports I will be using. As you can see it's outer edge will extend about 2.5mm from the baffle (if I don't recess it which I don't have the tools to do) due to the flange with the screw holes. From where do I measure the length of the port? From where it starts (2.5mm out from the front baffle) or from the outside of the baffle?

/Erik

Report message to a moderator

[Message index]

		Building a pair of 2 Pi in solid pine? By: Erik Johansson on Sun, 14 July 2002 05:13
		Re: Building a pair of 2 Pi in solid pine? By: Wayne Parham on Sun, 14 July 2002 11:43
		Re: Building a pair of 2 Pi in solid pine? By: Erik Johansson on Sun, 14 July 2002 12:42
		Tolerance By: Wayne Parham on Sun, 14 July 2002 14:38
		Re: Tolerance By: Erik Johansson on Mon, 15 July 2002 10:04
		Re: Tolerance By: Wayne Parham on Mon, 15 July 2002 10:56
		Re: Tolerance By: Erik Johansson on Mon, 15 July 2002 11:15
		Re: Tolerance By: BillEpstein on Mon, 15 July 2002 19:36
		Re: Building a pair of 2 Pi in solid pine? By: vladimir4 on Mon, 15 July 2002 00:34

Previous Topic:	T/S on the JBL 115H woofer
Next Topic:	Wayne or anybody: L-pad values

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Feb 01 12:59:44 CST 2025