Home » Sponsored » Pi Speakers » theater4pi and stage4pi for M252?
M252s [message #37099 is a reply to message #37081] Thu, 27 June 2002 14:13 Go to previous messageGo to previous message
dbeardsley is currently offline  dbeardsley
Messages: 2
Registered: May 2009
Esquire
I've used four of these woofers in a few different setups.. they aren't tuned super low (can't really get 20hz out of them at all), but they have a powerful motor and lots of xmax and perform very well in properly tuned cabinets.

I built a electric bass cab for my friend. 5.3 cuft, tuned at 36hz. really nice sounding, f3 of 50zh and f10 of 30hz (only a 1db hump at 100hz), it really sounded good, and was within excursion limits at full power.

I also have one each in a pair of 8cu ft sealed cabinets, which I'm going to tune to probably 33hz to give an f3 of 45hz and an f10 of 25hz. Only 6db down at 30hz.

These woofers sound very nice. They go really high too. and are very smooth (small 1 or 2db humps at 4k) until they drop 10db at about 4.8khz and then there are breakup modes after that. Truly 99 - 100 db efficient though.

They perform very nicely. I still have the JBL pdf for them if you would like it.

 
Read Message
Read Message
Read Message
Read Message
Previous Topic: Wayne-Now you've seen and heard.......
Next Topic: Plans for Thermionic 2 Pi, 3 Pi and 4 Pi
Goto Forum:
  


Current Time: Mon Nov 25 05:42:51 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest