AudioRoundTable.com: Pi Speakers » question about applying veneer

Home » Sponsored » Pi Speakers » question about applying veneer

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

question about applying veneer [message #36515]

Sat, 18 May 2002 16:33

ray99
Messages: 15
Registered: May 2009

Chancellor

Hi. I saw some relatively inexpensive veneer at Home Depot. Is it simply a matter of cutting to fit, applying contact glue and then trimming with a router? I've heard about "bubbling" but Im not sure what this means. Thanks for any tips. Ray

Report message to a moderator

Re: question about applying veneer [message #36516 is a reply to message #36515]

Sat, 18 May 2002 17:31

BillEpstein
Messages: 886
Registered: May 2009

Illuminati (2nd Degree)

Don't know what wood veneer HD might sell but if it's wood and unbacked, not for the faint hearted beginner. NBS backed is good with contact adhesive and of course plastic laminate like Formica, Wilson Art, etc.
Most problems are due to not using 2 coats of glue; waiting too long or too short a time to apply or application in too cold temps. Other than that it's just what you say.

Report message to a moderator

Previous Topic:	4 Pi questions
Next Topic:	group delay

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Nov 29 13:22:44 CST 2024