AudioRoundTable.com: Pi Speakers » mdf cabinet assembly question

Home » Sponsored » Pi Speakers » mdf cabinet assembly question

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: mdf cabinet assembly question [message #36444 is a reply to message #36440]

Thu, 16 May 2002 07:43

SteveBrown
Messages: 330
Registered: May 2009

Grand Master

On MDF I have had good success using butt joints and just glue - no screws. I like to assemble the front, sides, top and bottom all at once. It is a bit awkward and you will need some clamps. Using screws can help this - it eliminates the need for clamps. The reason I do it this way is that I get a better fit around the front baffle. Also, on MDF if your edges are a bit proud you can use a flush trimming bit on a router to just wiz them down to a nice flat finish with the other panels.
Steve

Report message to a moderator

[Message index]

		mdf cabinet assembly question By: ray99 on Thu, 16 May 2002 06:09
		not sure about the other guys By: Sam P. on Thu, 16 May 2002 06:32
		cab assy By: Paul C. on Thu, 16 May 2002 14:05
		Re: not sure about the other guys By: RJW on Thu, 16 May 2002 15:45
		Black pan screws for mounting small drivers By: Wayne Parham on Fri, 17 May 2002 12:07
		Re: Black pan screws for mounting small drivers By: RJW on Mon, 20 May 2002 17:19
		Re: mdf cabinet assembly question By: SteveBrown on Thu, 16 May 2002 07:43
		flush trimming router bit By: Sam P. on Thu, 16 May 2002 08:05
		thanks for the responses (NT) By: ray99 on Thu, 16 May 2002 16:44

Previous Topic:	good info site
Next Topic:	Pi Speaker enclosure for Coaxial

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Nov 30 11:06:19 CST 2024