AudioRoundTable.com: Pi Speakers » 14ga solid copper wire? (for Wayne)

Home » Sponsored » Pi Speakers » 14ga solid copper wire? (for Wayne)

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

14ga solid copper wire? (for Wayne) [message #36033]

Thu, 18 April 2002 15:17

mhammill
Messages: 23
Registered: May 2009

Chancellor

In an previous post you said not to use thin gauge magnet wire due to the resistance but to use 18 or 16 ga stranded copper and then added not to use heavier gauge solid strand copper either. This was in a post on the bottlehead forum to Garland.
Just curious why not the 14ga solid copper?

Thanks
Mike H.

Report message to a moderator

[Message index]

		14ga solid copper wire? (for Wayne) By: mhammill on Thu, 18 April 2002 15:17
		Speaker cable and wire properties, revisited By: Wayne Parham on Thu, 18 April 2002 19:22
		you can only tighten binding posts so much By: Sam P. on Fri, 19 April 2002 05:46

Previous Topic:	attenuating 1197 piezo
Next Topic:	People using Paramours...

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Dec 01 03:36:54 CST 2024