AudioRoundTable.com: Pi Speakers » crossover design... help....

Home » Sponsored » Pi Speakers » crossover design... help....

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: crossover design... help.... [message #35994 is a reply to message #35990]

Tue, 16 April 2002 09:34

Wayne Parham
Messages: 18789
Registered: January 2001

Illuminati (33rd Degree)

>> i want to build the speakers with the capability of being bi-amplified,
>> so, it is OK if i wire the direct inputs straight to the drivers, with the
>> crossover still conected? or i must disconnect the crossovers to avoid problems?

Disconnect them. When using an active crossover and bi-amp, disconnect all reactive components from the speakers, and put them between the preamp and amp instead.

Report message to a moderator

[Message index]

		crossover design... help.... By: Pilkar on Mon, 15 April 2002 06:46
		Re: crossover design... help.... By: Wayne Parham on Mon, 15 April 2002 10:41
		Re: crossover design... help.... By: Pilkar on Mon, 15 April 2002 11:40
		did you mean the D205Ti driver? By: Sam P. on Mon, 15 April 2002 14:38
		Re: did you mean the D205Ti driver? By: Pilkar on Tue, 16 April 2002 05:11
		Re: crossover design... help.... By: Wayne Parham on Mon, 15 April 2002 15:00
		Re: crossover design... help.... By: Pilkar on Tue, 16 April 2002 04:51
		Re: crossover design... help.... By: Wayne Parham on Tue, 16 April 2002 09:34
		Re: crossover design... help.... By: Pilkar on Tue, 16 April 2002 11:42
		You have mail! By: Wayne Parham on Tue, 16 April 2002 14:54

Previous Topic:	Horn flare survey
Next Topic:	Folded horn subs--yuck!

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Nov 29 05:27:33 CST 2024