AudioRoundTable.com: Pi Speakers

Home » Sponsored » Pi Speakers » Horn flare survey

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

I'm sure Wayne will provide proper bolts [message #35982 is a reply to message #35941]

Mon, 15 April 2002 15:44

Sam P.
Messages: 307
Registered: May 2009

Grand Master

so I vote for the H290. I don't care for the prominent seam on the CH3. I would have used some nice socket head bolts...of course the hardware store had only 3! Sam

BTW, you all DID put the bolts thru the holes in the horn first, and then put the driver in position, slowly turning the bolts into the holes threaded in the driver, right? I don't recall interference...

Report message to a moderator

[Message index]

		Horn flare survey By: Wayne Parham on Fri, 12 April 2002 14:44
		Re: Horn flare survey By: bmar on Fri, 12 April 2002 15:00
		Re: Horn flare survey By: dbeardsl on Fri, 12 April 2002 15:45
		Re: Horn flare survey By: replay on Fri, 12 April 2002 16:50
		H 290 (nt) By: Rex Mills on Fri, 12 April 2002 17:29
		Re: Horn flare survey By: steve f on Fri, 12 April 2002 18:37
		Re: Horn flare survey By: BillEpstein on Fri, 12 April 2002 19:10
		Re: Horn flare survey By: Garland on Sat, 13 April 2002 02:21
		Re: Horn flare survey By: trancemitr on Sat, 13 April 2002 15:01
		Re: Horn flare survey By: boblaz on Sat, 13 April 2002 16:06
		Take 290, stick to Eminence for whole speaker (nt) By: Erik from Holand on Mon, 15 April 2002 00:05
		290 - Same bang, less buck (nt) By: JLapaire on Mon, 15 April 2002 05:48
		Re: Horn flare survey By: Hodel on Mon, 15 April 2002 12:01
		I'm sure Wayne will provide proper bolts By: Sam P. on Mon, 15 April 2002 15:44
		Thanks for all your input! By: Wayne Parham on Tue, 16 April 2002 00:21
		What can be done about the inconsistent bolt holes?(nt) By: Garland on Tue, 16 April 2002 06:49
		Use 1/4"-20 x 3/4" bolts By: Wayne Parham on Tue, 16 April 2002 09:38

Previous Topic:	Wayne, what about the compensation network??
Next Topic:	crossover design... help....

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Dec 01 13:51:27 CST 2024