AudioRoundTable.com: Pi Speakers

Home » Sponsored » Pi Speakers » PSD2002 Horn

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

PSD2002 Horn [message #35852]

Sun, 07 April 2002 08:40

KevinP
Messages: 12
Registered: May 2009

Chancellor

I'm not sure of the suitability but thought I'd post about these since if they would work they could save a few builders a few hare earned $$$.

http://www.partsexpress.com/pe/pshowdetl.cfm?&DID=7&Partnumber=269-109

Maybe Wayne could comment on the suitability for use with Pi speakers?

Report message to a moderator

Re: PSD2002 Horn [message #35857 is a reply to message #35852]

Sun, 07 April 2002 15:28

Wayne Parham
Messages: 18792
Registered: January 2001

Illuminati (33rd Degree)

Sorry, I dunno. Haven't used 'em. Danny mentioned these too in an earlier post, so thanks for reminding us. At ten bucks each, it looks like they might be worth a try.

Report message to a moderator

Mon, 08 April 2002 08:09

Sam P.
Messages: 307
Registered: May 2009

Grand Master

the construction is much thinner, from a harder, "more brittle sounding" polycarbonate or something, not the same as the H-290 plastic. The brass insert looks well machined, at any rate. I just wanted to use the included 2/3 bolt to screw-on adapters as "drilling jigs" to allow the use of jbl 2426's and other 1 inch, 3 bolt drivers on my 511's (oem is 2 bolt) in the future. Sam

Report message to a moderator