AudioRoundTable.com: Pi Speakers » VERY easy CH-3 question

Home » Sponsored » Pi Speakers » VERY easy CH-3 question

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: I was going to use... [message #35288 is a reply to message #35278]

Sat, 02 March 2002 04:29

BillEpstein
Messages: 886
Registered: May 2009

Illuminati (2nd Degree)

I looked around a bit at MacMaster-Carr and didn't really find the right bolt but it might be in their printed catalogue. I'm also going to post and poke around at Madisound. What's a "button head" screw? and where do you get them?
I'm looking for what I know as a "washer head" screw; an oversize pan-head used to attach drawer fronts to drawer boxes.

http://www.mcmaster.com

Report message to a moderator

[Message index]

		VERY easy CH-3 question By: trancemitr on Fri, 01 March 2002 07:01
		Re: VERY easy CH-3 question By: Adam on Fri, 01 March 2002 07:57
		I was going to use... By: trancemitr on Fri, 01 March 2002 08:10
		Re: I was going to use...Unfortunately..... By: BillEpstein on Fri, 01 March 2002 13:44
		I've never actually seen.... By: LuxmanLover on Fri, 01 March 2002 14:53
		this project keeps getting more and more complicated (nt) By: trancemitr on Fri, 01 March 2002 16:05
		Re: "Button Head" cap screws are good <nt> By: bmar on Fri, 01 March 2002 20:03
		Re: I was going to use... By: BillEpstein on Sat, 02 March 2002 04:29
		Re: Button Heads By: bmar on Sat, 02 March 2002 11:25
		BMAR, you've done it again! Thanks. nt By: BillEpstein on Sat, 02 March 2002 12:52
		Re: VERY easy CH-3 question By: steve f on Sat, 02 March 2002 06:55

Previous Topic:	Four Pi's -- ports on the inside or outside edge?
Next Topic:	horn cutting adventure, murphy helped too!

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Sep 12 00:33:16 CDT 2024