AudioRoundTable.com: Pi Speakers » crossover component burn-in:)

Home » Sponsored » Pi Speakers » crossover component burn-in:)

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: diffraction issues again... [message #35259 is a reply to message #35252]

Wed, 27 February 2002 16:25

Wayne Parham
Messages: 18792
Registered: January 2001

Illuminati (33rd Degree)

Just a reminder: I think you're getting pretty usable information from your test setup but remember that it's tough to get really accurate information from a Radio Shack SPL meter. The resolution just isn't there. And indoors, you're measuring the room more than you're measuring the speakers. Even measurement systems with time gating are limited indoors, because reflections are too early to gate out. This prevents accurate measurements below midrange frequencies indoors, even on the best measurement systems.

Report message to a moderator

[Message index]

		crossover component burn-in:) By: Sam P. on Wed, 27 February 2002 07:00
		1.0 mH too much choke for dual 2226J's? By: Sam P. on Wed, 27 February 2002 09:04
		Multiple point sources and destructive interference By: Wayne Parham on Wed, 27 February 2002 11:31
		imaginary dip/measurement artifact By: Sam P. on Wed, 27 February 2002 15:03
		Re: imaginary dip/measurement artifact By: Wayne Parham on Wed, 27 February 2002 15:45
		Re: imaginary dip/measurement artifact By: Adam on Wed, 27 February 2002 16:24
		diffraction issues again... By: Sam P. on Wed, 27 February 2002 13:43
		Re: diffraction issues again... By: Wayne Parham on Wed, 27 February 2002 16:25
		measurement system DOES suk By: Sam P. on Thu, 28 February 2002 05:23
		screwed by geometry, By: Sam P. on Thu, 28 February 2002 06:40

Previous Topic:	Making sure before I buy
Next Topic:	Pi 2's with Bottlehead Paramour Review

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Tue Dec 03 05:20:54 CST 2024