AudioRoundTable.com: Pi Speakers » crossover component burn-in:)

Home » Sponsored » Pi Speakers » crossover component burn-in:)

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

crossover component burn-in:) [message #35244]

Wed, 27 February 2002 07:00

Sam P.
Messages: 307
Registered: May 2009

Grand Master

Wayne,
What better way to amuse myself while "killing time sanding" the enclosures, than to test/burn-in these new 4 Pi Pro xovers...on the jbl 4648A-8 based HT fronts. Just hooked up the coil (1.0 mH 14 ga.) in series with the 2226J woofers (no cap, OK!), HP is text book 1600 Hz. 3rd order w/ Pi pad/comp of 12 dB, feeding altec 902-8B's on 511's. Initial impression is very favorable in comparison to "normal" 600 Hz. BW's or the series 1200 Hz. 1st order I have also been using, but they both ran the HF "uncomped", just shelved 12 dB. I have some 0.8 mH 14 ga. coils to try later, for use when the 4 Pi Pro's are being tested/put in service. Sam

Report message to a moderator

[Message index]

		crossover component burn-in:) By: Sam P. on Wed, 27 February 2002 07:00
		1.0 mH too much choke for dual 2226J's? By: Sam P. on Wed, 27 February 2002 09:04
		Multiple point sources and destructive interference By: Wayne Parham on Wed, 27 February 2002 11:31
		imaginary dip/measurement artifact By: Sam P. on Wed, 27 February 2002 15:03
		Re: imaginary dip/measurement artifact By: Wayne Parham on Wed, 27 February 2002 15:45
		Re: imaginary dip/measurement artifact By: Adam on Wed, 27 February 2002 16:24
		diffraction issues again... By: Sam P. on Wed, 27 February 2002 13:43
		Re: diffraction issues again... By: Wayne Parham on Wed, 27 February 2002 16:25
		measurement system DOES suk By: Sam P. on Thu, 28 February 2002 05:23
		screwed by geometry, By: Sam P. on Thu, 28 February 2002 06:40

Previous Topic:	Making sure before I buy
Next Topic:	Pi 2's with Bottlehead Paramour Review

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Mon Dec 02 01:56:59 CST 2024