I'm a little unsure how to filter or not?
Does Studio 2 Pi use any crossover?
I would prefer crossoveless design.
Could I simply put a 16 Ohm resistor parallel with KSN1038 , and that's it? , looks like the slopes of the drivers match?
Also I have seen your tread:
"The best match for this is a third order electrical filter, which will provide an 18dB/octave slope. The best way to do this is to use a 16 ohm resistor directly across the tweeter. Next, use a 4.7uF capacitor in series. Then a 12 ohm resistor in parallel, and a 1.6uF capacitor in series, in front of that. Typical Butterworth arrangement, but using resistors instead of inductors."
Will this be better for me.
Final question , do you have the Pi logo in .jpg format in natural size?
Best Regards
Jan Bundgaard