Home » Sponsored » Pi Speakers » Wayne, double loading
Wayne, double loading [message #34564] Fri, 28 December 2001 12:57 Go to next message
Adam is currently offline  Adam
Messages: 419
Registered: May 2009
Illuminati (1st Degree)
Hey Wayne,

Well I was sitting on my couch and envisioning my four, huge 10 pi's flanking either side of my crappy television, and I started thinking about home theatre!!! I figure if I ever had a big, big tv room, that I could use these four as front left and front right and the two sourrounds. But... I would have no center channel!

I also figure that another 10 pi would never fit properly standing up under a tv set, and you couldn't place it off to the side.

Here's what I came up with. The picture that I attached is a top view. As you can see it's basically a 10 pi, but rather then one large horn, there are two smaller ones, each taking up half the woofer's cone area, each with half the port area and volume. Same box dimensions, just a smaller horn loading off both sides.

What do you think? Would this have the same effect or no? Also, would it cause the setup to act as an MTM speaker?

Thanks.

Adam

correction. [message #34565 is a reply to message #34564] Fri, 28 December 2001 12:59 Go to previous messageGo to next message
Adam is currently offline  Adam
Messages: 419
Registered: May 2009
Illuminati (1st Degree)
Sorry, port area should be mouth area. I would probably add two 4" ports so each side had a port loading into it.

Adam

W-Folding for bass bins [message #34566 is a reply to message #34565] Fri, 28 December 2001 13:32 Go to previous messageGo to next message
Wayne Parham is currently offline  Wayne Parham
Messages: 18786
Registered: January 2001
Illuminati (33rd Degree)
You're talking about a "W-fold" like used in the Klipsch La Scala instead of the spiral fold normally used in the ten π. That's fine as long as path, area and expansion rate remain the same.
Re: W-Folding for bass bins [message #34567 is a reply to message #34566] Fri, 28 December 2001 20:17 Go to previous message
Adam is currently offline  Adam
Messages: 419
Registered: May 2009
Illuminati (1st Degree)
Sweet.

Wayne, I'm gonna have the sickest 5.1 theatre ever, lol.

You can post a pic of them on your site!!! Hehe.

Thanks!!!

Adam

Previous Topic: Is this horn flare suitable for PSD2002?
Next Topic: Is it possible to build the 4 Pi's as 16 ohm speakers?
Goto Forum:
  


Current Time: Tue Nov 26 19:47:33 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest