AudioRoundTable.com: Pi Speakers » Question for Wayne - Compensation Network Resistor Chain

Home » Sponsored » Pi Speakers » Question for Wayne - Compensation Network Resistor Chain

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Question for Wayne - Compensation Network Resistor Chain [message #34403]

Thu, 13 December 2001 07:33

Garland
Messages: 269
Registered: May 2009

Grand Master

I've noticed in the previous postings that there are different ways to gang the resistors to come up with the required 40W power handling for the Theater 4 Pi network. I thought I would assemble 2 series pairs of 15ohm-12w mills in parallel to create an equivalent 15ohm 24w resistor network. Since I plan on driving these speakers with low powered tube amps is this the way to do it? I have 16 of the Mills 15ohm - 12w resistors so I hope I'm OK and don't have to re-order. These ain't cheap! Though I guess I could go for the cement resistors which aren't too bad. And I assume 15ohms is close enough to the 16ohm spec to work properly!?

Garland (and thanks!)

Report message to a moderator

[Message index]

		Question for Wayne - Compensation Network Resistor Chain By: Garland on Thu, 13 December 2001 07:33
		I know I'm not Wayne, but... By: Colin Fritzke on Thu, 13 December 2001 09:11
		Re: I know I'm not Wayne, but... By: Frode on Thu, 13 December 2001 11:58
		Crossover Resistors By: Wayne Parham on Thu, 13 December 2001 15:26
		....I play him on TV By: mikebake on Fri, 14 December 2001 07:14

Previous Topic:	Modification to cabinet proportions OK, Wayne?
Next Topic:	March 29-30 looks like the date

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Dec 01 05:06:57 CST 2024