AudioRoundTable.com: Pi Speakers » Pi Aligned Afterburner & Port Calculation

Home » Sponsored » Pi Speakers » Pi Aligned Afterburner & Port Calculation

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Pi Aligned Afterburner & Port Calculation [message #33949 is a reply to message #33942]

Thu, 27 September 2001 11:26

Wayne Parham
Messages: 18783
Registered: January 2001

Illuminati (33rd Degree)

You used 2.4 as as cabinet volume but you should have used 2.4 x 1728 to convert it to cubic inches. You must use the same terms throughout - If inches in one place then inches must be used everywhere. You can use feet if you wish, but then the port dimensions must be in feet for "Lc" and sq. feet for "Ap".

Report message to a moderator

[Message index]

		Pi Aligned Afterburner & Port Calculation By: Observator on Thu, 27 September 2001 06:43
		Re: Pi Aligned Afterburner & Port Calculation By: Wayne Parham on Thu, 27 September 2001 11:26
		Re: Pi Aligned Afterburner & Port Calculation By: Observator on Sat, 29 September 2001 13:02
		Re: Pi Aligned Afterburner & Port Calculation By: Wayne Parham on Sat, 29 September 2001 16:07
		Thanks a lot ! (nt) By: Observator on Sun, 30 September 2001 03:39
		Re: Pi Aligned Afterburner & Port Calculation By: AudioLapDance on Thu, 27 September 2001 12:57
		Re: Pi Aligned Afterburner & Port Calculation By: Observator on Sat, 29 September 2001 13:36

Previous Topic:	Which drivers are suitable for Pi alignment?
Next Topic:	Pair of JBL 2426H drivers FS.

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Nov 15 19:59:51 CST 2024