AudioRoundTable.com: Pi Speakers » Using Eminence Gamma 10

Home » Sponsored » Pi Speakers » Using Eminence Gamma 10

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Using Eminence Gamma 10 [message #33838]

Mon, 10 September 2001 12:01

STUART
Messages: 4
Registered: May 2009

Esquire

Hi
I am trying to make the best of what seems to be a bad speaker purchase. Based on the assertion on the Eminence web page that the Gamma 10 is "suitable for all hi power bass applications including bass guitar", I chose one of these drivers to make a small cabinet for my bass amp. I can't remember the exact cabinet specs, but made it according to the recommendations of a couple of design programs. The results have been disappointing, particularly low frequency response.

Eminence seems to be a fairly significant discussion point on this board. Would any of the participants here have any suggestions or opinions on whether this speaker could be "made" to work in this application? Would using Pi Alignment make any difference vs. the typical ported design? If it helps, Vad=1.29 cu ft., Fs = 63 Hz, and Qd = 1.96.

Thanks for your help and opinions.
Stuart

Report message to a moderator

[Message index]

		Using Eminence Gamma 10 By: STUART on Mon, 10 September 2001 12:01
		...as a midbass driver or bookshelf speaker By: Wayne Parham on Mon, 10 September 2001 13:37
		Sigh!...That's what I thought By: STUART on Mon, 10 September 2001 15:11

Previous Topic:	Source for peavey CH-3? (NT)
Next Topic:	The Sawboard: a circular saw guide that works!

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Nov 27 07:37:54 CST 2024