AudioRoundTable.com: Pi Speakers

Home » Sponsored » Pi Speakers » JBL 2410 drivers

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

JBL 2410 drivers [message #33559]

Sun, 15 July 2001 22:15

James W. Johnson
Messages: 199
Registered: May 2009

Master

How decent is the JBL 2410 driver? I noticed some on Ebay. I have decided to go the cheap route for the four Pis, I picked up a used pair of 2226H drivers for $350 and I also want to find used tweeters.

Report message to a moderator

Re: JBL 2410 drivers [message #33560 is a reply to message #33559]

Sun, 15 July 2001 23:45

Wayne Parham
Messages: 18791
Registered: January 2001

Illuminati (33rd Degree)

Yes, that driver will work. You might look at the Eminence PSD2002 too, because it costs about the same new as a used JBL driver. It's a pretty good driver, especially for the price.

Report message to a moderator

Re: JBL 2410 drivers [message #33561 is a reply to message #33560]

Mon, 16 July 2001 02:42

James W. Johnson
Messages: 199
Registered: May 2009

Master

Is this the proper version of the PSD2002 that I need?

http://www.partsexpress.com/pe/showdetl.cfm?&DID=7&Product_ID=7610&CATID=49

Report message to a moderator

Re: JBL 2410 drivers [message #33562 is a reply to message #33561]

Mon, 16 July 2001 02:48

James W. Johnson
Messages: 199
Registered: May 2009

Master

By the way , at this point I don't have a choice because Parts Express has dropped the price of the PSD2002 to $61.01ea! and the H290 is only $29.11.

Report message to a moderator

four Pi parts [message #33563 is a reply to message #33562]

Mon, 16 July 2001 03:23

Wayne Parham
Messages: 18791
Registered: January 2001

Illuminati (33rd Degree)

That's the right driver, but you'll need to get the PSD2002 bolt-on version to mount on the H290 horn.

Report message to a moderator

Re: four Pi parts [message #33564 is a reply to message #33563]

Mon, 16 July 2001 08:52

James W. Johnson
Messages: 199
Registered: May 2009

Master

Thanks Wayne, I understand everything in the plans except the tweeter circuit..... Is this how you do it? -----0.47uF----- | | Crossover tweeter out (+) -------|------16ohm--------- Tweeter (+) | | 16ohm | | Crossover tweeter out (-) ---------------------------- Tweeter (-) Is this correct?
James

Report message to a moderator

Re: four Pi parts [message #33565 is a reply to message #33564]

Mon, 16 July 2001 08:59

James W. Johnson
Messages: 199
Registered: May 2009

Master

Doh, that's what the crossover shows. I meant to show you how I think I'm supposed to make each 16 ohm resistor: |----16ohm--------16ohm----| ---| |--- |----16ohm--------16ohm----| Is that right?

Report message to a moderator