AudioRoundTable.com: Pi Speakers » Any thoughts about the Peavey 22XT?

Home » Sponsored » Pi Speakers » Any thoughts about the Peavey 22XT?

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Any thoughts about the Peavey 22XT? [message #33372]

Tue, 22 May 2001 21:49

Bridgetown
Messages: 9
Registered: May 2009

Esquire

I am about to start building my Pi7 horns, recently received the plans recently from Wayne. I have a pair of Peavey 22XT compression drivers. I have not seen any discussion about Peavey 22XT in the forum and I am not sure if this driver would make a suitable as high frequency unit for the Pi7.

The specifications are as follows:
Throat parameter: 1"
Nonimal impedenance: 8 ohms
Sensitivity : 111dB SPL 1w/1m on a CH-2 horn
Frequency range: 500-20,000 Hz
Frequency range: +/- 2dB 500-3,200 Hz, -3dB@8,000 Hz
6dB roll off from 8,000-20,000 Hz
Diaphragm: titanium
Power capacity : 40 watts

I would appreciate any comments regarding its suitability and possible compensation network.
Regards

Report message to a moderator

Re: Any thoughts about the Peavey 22XT? [message #33373 is a reply to message #33372]

Tue, 22 May 2001 22:55

Wayne Parham
Messages: 18709
Registered: January 2001

Illuminati (33rd Degree)

Do you happen to have response measured on a plane wave tube?

Report message to a moderator

Re: Any thoughts about the Peavey 22XT? [message #33374 is a reply to message #33373]

Wed, 23 May 2001 00:18

Bridgetown
Messages: 9
Registered: May 2009

Esquire

Wayne

Thank you for your response to my post. No, I don't have any measurements but maybe they are published somewhere. I am living in Barbados and I purchased the components from a pro audio shop locally.

Report message to a moderator