AudioRoundTable.com: Group Build

Home » Audio » Group Build » Butt-joint veneer

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Hey Colin, get out that fancy router and table saw [message #32167 is a reply to message #32166]

Thu, 26 April 2007 20:09

Bill Epstein
Messages: 1088
Registered: May 2009
Location: Smoky Mts. USA

Illuminati (2nd Degree)

Rout off the corners of the cabinet creating a 1/2" wide rabbet on the front and adjacent side. Glue in a strip of hardwood and leave it 1/4" proud of the substrate + veneer. The proud edge of the hardwood after you veneer looks like you did it on purpose and the shadow line it creates is a nice detail.

No seam needed.

Your Uncle Bill

Report message to a moderator

[Message index]

		Butt-joint veneer By: colinhester on Sat, 07 April 2007 14:18
		Re: Butt-joint veneer By: Seeker on Tue, 10 April 2007 12:41
		Re: Butt-joint veneer By: colinhester on Tue, 10 April 2007 21:22
		Re: Butt-joint veneer By: Seeker on Wed, 11 April 2007 09:20
		Re: Butt-joint veneer By: colinhester on Wed, 11 April 2007 13:02
		Re: Hey Colin, get out that fancy router and table saw By: Bill Epstein on Thu, 26 April 2007 20:09

Previous Topic:	The ausio Asylum is done
Next Topic:	ART arrays near Iowa, Nebraska???

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Aug 11 07:22:33 CDT 2024