AudioRoundTable.com: Group Build » If your thinking about an aluminum top plate and using a nibbler.....

Home » Audio » Group Build » If your thinking about an aluminum top plate and using a nibbler.....

Tue, 03 October 2006 21:50

Forty2wo
Messages: 163
Registered: May 2009

Master

Try a jewelers saw, or other very fine copeing saw blade. It is actually faster and easier than drilling a line of holes then cleaning them up…John

		If your thinking about an aluminum top plate and using a nibbler..... By: Bill Epstein on Mon, 02 October 2006 18:27
		Re: If your thinking about an aluminum top plate and using a nibbler..... By: cfranz on Tue, 03 October 2006 08:20
		Re: If your thinking about an aluminum top plate and using a nibbler..... By: Wayne Parham on Tue, 03 October 2006 08:47
		Re: If your thinking about an aluminum top plate and using a nibbler..... By: cfranz on Tue, 03 October 2006 09:01
		Re: If your thinking about an aluminum top plate and using a nibbler..... By: Wayne Parham on Tue, 03 October 2006 12:35
		Re: If your thinking about an aluminum top plate and using a nibbler..... By: Forty2wo on Tue, 03 October 2006 21:50
		Where'd ya get em' By: Shane on Tue, 03 October 2006 16:49
		Re: Where'd ya get em' By: Bill Epstein on Tue, 03 October 2006 20:00
		Re: If your thinking about an aluminum top plate and using a nibbler..... By: SteveBrown on Thu, 05 October 2006 11:54
		Re: Hey Steve, By: Bill Epstein on Thu, 05 October 2006 15:49
		Re: Hey Steve, By: SteveBrown on Thu, 05 October 2006 18:40
		Sourcing for plate By: Shane on Tue, 17 October 2006 16:47
		Re: Sourcing for plate By: Wayne Parham on Sat, 21 October 2006 17:47
		Re: Yo, Shane By: Bill Epstein on Sat, 21 October 2006 20:42

Previous Topic:	The "Evil" Dr. Brown
Next Topic:	300B SE Project, Part 8 - Common cathode 6SN7 triode driver

Goto Forum:

] [

]

Current Time: Sun Jul 28 18:18:48 CDT 2024