Home » Audio » Group Build » SE 300B Project, Part 12 - C3g driver
Re: Do you think it is possible... [message #31889 is a reply to message #31888] Tue, 23 May 2006 14:28 Go to previous messageGo to previous message
Damir is currently offline  Damir
Messages: 1005
Registered: May 2009
Illuminati (2nd Degree)
IMO - no, the voltage "swing" is only +/- 70Vp maximum, B1+ = 400-410V and Ua=190V. Lacking the scope, I can`t see the waveshape at the CCS output, I can only tell what I heard. The sound is very clean and direct - not a sight of distortion.
I think that Pete Millett measured about 0,04% THD with CCS-ed D3a in triode with 10Vrms out...It is about 0,2% with 50Vrms out, pretty good.
The load is high-impedance grid choke.
Again, I don`t have a THD meter...huh. But, Russ - I lose the interest about theoretical speculations a bit - this empiric (trying different things and listening test) phase is even more interesting. I`d also like to know why the tube with lower rp sounds "softer" then similar, higher rp one? Then sound of capacitors and resistors, PS...
Yes, I have various theories...based mostly on theory - but again, without proper measurements I can have just the part of the picture, for now.
Anyway, the amp sounds fine - I think that I`ll use E180F for the driver...huh, I have only two....for now...


 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: The bass is back.
Next Topic: tried the 6688
Goto Forum:
  


Current Time: Sat Nov 30 13:00:05 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest