AudioRoundTable.com: Group Build » New PCB for the CCS

Home » Audio » Group Build » New PCB for the CCS

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

New PCB for the CCS [message #31042]

Fri, 15 April 2005 13:52

Damir
Messages: 1005
Registered: May 2009

Illuminati (2nd Degree)

Hi, nice to be back...
I built two "universal" CCS "module" on the PCB. Marker and nail- polish, then Fe-III-Chlorid, as usual...Thanks Doug for the mosfets:-)
I added local decoupling cap 1uF/630V (not necessary). Dimensions of the board are 32x75mm. As you can see, I didn`t install R3 yet, I planned to use a fixed resistor. I tried both CCS with battery and they worked, but didn`t try it in the real circuit so far...

Report message to a moderator

Re: New PCB for the CCS - 2 [message #31043 is a reply to message #31042]

Fri, 15 April 2005 13:54

Damir
Messages: 1005
Registered: May 2009

Illuminati (2nd Degree)

Another view:

Report message to a moderator

Welcome back [message #31044 is a reply to message #31043]

Sat, 16 April 2005 10:02

colinhester
Messages: 1349
Registered: May 2009
Location: NE Arkansas

Illuminati (3rd Degree)

Damir, It's nice to see you're back......Colin

Report message to a moderator

Re: New PCB for the CCS - 2 [message #31045 is a reply to message #31043]

Sat, 16 April 2005 10:54

Wayne Parham
Messages: 18792
Registered: January 2001

Illuminati (33rd Degree)

Welcome back!

I'm eager to start an amp project. I know, I never got started on my preamp. But I did save a pair of 2A3's in the hopes we might do something with them here.

Report message to a moderator

Re: Welcome back [message #31046 is a reply to message #31044]

Sat, 16 April 2005 12:07

Damir
Messages: 1005
Registered: May 2009

Illuminati (2nd Degree)

Thank you all.
New projects (2A3) - actually, I have SE 300B in my mind first. Probably I`ll write about it gradually - output stage, PS, various drivers, etc. - till the finished amp. I have many "breadboard" experiments in plan, expecting new PT from Netherlands, and I hope that I`ll find time/will to post it continuously... I`ll try my best, but don`t expect too much...

Most of the time

Report message to a moderator

Re: Welcome back [message #31047 is a reply to message #31046]

Sat, 16 April 2005 14:18

colinhester
Messages: 1349
Registered: May 2009
Location: NE Arkansas

Illuminati (3rd Degree)

Damir, I never had a chance to properly thank you for your help with the preamp. Your hand drawn schematic was what I used to wire it up. I don't think I could have done it otherwise. There were a few glitches along the way, but they were my fault. See link for picture of the top.

I'm curious to see what amp you're working on now. Please keep us posted!!!

Colin