AudioRoundTable.com: Group Build

Home » Audio » Group Build » Filament Caps

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

That's what I used [message #30813 is a reply to message #30812]

Fri, 04 March 2005 08:03

colinhester
Messages: 1349
Registered: May 2009
Location: NE Arkansas

Illuminati (3rd Degree)

I used what was on the heater schematic, which was 4.7 mF (4700uF)and I believe 25V rating. See link below and remember the resistors were changed to 2 and 2 ohm......Colin

http://audioroundtable.com/GroupBuild/messages/397.html

Report message to a moderator

[Message index]

		Filament Caps By: Manualblock on Fri, 04 March 2005 06:47
		That's what I used By: colinhester on Fri, 04 March 2005 08:03
		Re: That's what I used By: Manualblock on Fri, 04 March 2005 08:22
		That's what I used By: PakProtector on Fri, 04 March 2005 08:29
		Less ripple w/10k uF By: colinhester on Fri, 04 March 2005 08:47
		Re: Less ripple w/10k uF By: Manualblock on Fri, 04 March 2005 09:06
		Re: Less ripple w/10k uF By: PakProtector on Fri, 04 March 2005 10:21
		Re: Less ripple w/10k uF By: Manualblock on Fri, 04 March 2005 11:15
		Is cap size worth increasing in heater PS? By: colinhester on Fri, 04 March 2005 13:18
		Re: Is cap size worth increasing in heater PS? By: Manualblock on Fri, 04 March 2005 13:35
		Up and running w/ about 15 hours on the pre By: colinhester on Fri, 04 March 2005 13:43

Previous Topic:	Mounting Coupling caps
Next Topic:	More amp design considerations

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Nov 30 14:14:47 CST 2024