AudioRoundTable.com: Group Build » LEDs light - can I assume CCS is wires properly?

Home » Audio » Group Build » LEDs light - can I assume CCS is wires properly?

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Yeap, blown fuse [message #30765 is a reply to message #30764]

Mon, 28 February 2005 20:32

colinhester
Messages: 1349
Registered: May 2009
Location: NE Arkansas

Illuminati (3rd Degree)

Fuse in the DVM was gone. I remeasured from plate to ground and adjusted to 15mA; the voltage was 100VDC both channels. When adjusted to 130VDC as before the current was around 50mA. Staying at 15mA and 100VDC. And yes, the LEDs went out when measuring the current this time. Thanks a bunch......Colin

Report message to a moderator

[Message index]

		LEDs light - can I assume CCS is wires properly? By: colinhester on Mon, 28 February 2005 19:13
		Almost certainly By: PakProtector on Mon, 28 February 2005 19:44
		Dead on 130V and stupid question By: colinhester on Mon, 28 February 2005 20:07
		ummmmm By: PakProtector on Mon, 28 February 2005 20:13
		Yeap, blown fuse By: colinhester on Mon, 28 February 2005 20:32
		Re: Yeap, blown fuse By: cheetah on Mon, 28 February 2005 21:26
		Re: Yeap, blown fuse By: PakProtector on Tue, 01 March 2005 05:16

Previous Topic:	Guinever done
Next Topic:	Guinever underside

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Nov 24 23:51:31 CST 2024