AudioRoundTable.com: Group Build » LEDs light - can I assume CCS is wires properly?

Home » Audio » Group Build » LEDs light - can I assume CCS is wires properly?

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Almost certainly [message #30760 is a reply to message #30759]

Mon, 28 February 2005 19:44

PakProtector
Messages: 935
Registered: May 2009

Illuminati (2nd Degree)

sounds good to me so far. I would suggest putting a 10R resistor in series with the B+ lead to each CCS to measure the current. You don't want to run the LED's over current.

Or you could clip lead in the battery and measuring equipment to determine regulated curent amount.

Do measure before runnig extensively. You could get fairly close by adjusting current to give ~130 volts on the plate. With the 2x LED bias, it should be between 10 and 15 mA which is quite LED-safe.
regards,
Douglas

Report message to a moderator

[Message index]

		LEDs light - can I assume CCS is wires properly? By: colinhester on Mon, 28 February 2005 19:13
		Almost certainly By: PakProtector on Mon, 28 February 2005 19:44
		Dead on 130V and stupid question By: colinhester on Mon, 28 February 2005 20:07
		ummmmm By: PakProtector on Mon, 28 February 2005 20:13
		Yeap, blown fuse By: colinhester on Mon, 28 February 2005 20:32
		Re: Yeap, blown fuse By: cheetah on Mon, 28 February 2005 21:26
		Re: Yeap, blown fuse By: PakProtector on Tue, 01 March 2005 05:16

Previous Topic:	Guinever done
Next Topic:	Guinever underside

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Nov 28 16:55:45 CST 2024