Home » Audio » General » Time for GPAF!
Also [message #3071 is a reply to message #3069] Tue, 09 May 2006 17:00 Go to previous messageGo to previous message
FredT is currently offline  FredT
Messages: 704
Registered: May 2009
Illuminati (1st Degree)
I forgot to mention this enclosure is very easy to build because you are starting with pre cut 11.25" wide mdf boards. You cut all the panels exactly 36", then you trim four of them down to 9.75" for the front and back panels. The other four you use in their full 11.25" width for the sides. The top and bottom panels are already the correct 11.25" depth, so all you have to do is to cut them to the required 8.25" width. My yard charges 70 cents/ft for the precut mdf boards, so the total for the 32' needed to build two enclosures is just south of $25.

 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: WSOTT - Cinci edition - July 15
Next Topic: fostex up 203 super
Goto Forum:
  


Current Time: Mon Nov 25 23:36:47 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest