Home » Audio » Group Build » Going to build Gunevere with you guys...
but of course... [message #30637 is a reply to message #30636] Mon, 21 February 2005 16:34 Go to previous messageGo to previous message
PakProtector is currently offline  PakProtector
Messages: 935
Registered: May 2009
Illuminati (2nd Degree)

I have to get the R-set 1k trip pots. I hope R-S has them. I'm getting the little heatsinks from themtoo. 4-40 screws from Lowes to attach them to the TO-220 MOSFETS.

I loked at the box, there is no way I'm getting one of those 100-mike Pop-can sized caps under there. the sol'n is even cheaper. A trip to the photo shop for some disposable flash cameras. They have 100 uF/330 volt flash caps inside. a few hundred mikes of them ought to do the trick. I may put in a 6NO30 delay relay to turn on the 6CA4's heater...probably just put in a 40k bleeder resistor. Perhaps 33k as I have soem IRC GS3 3W metal film. The small resistro provides enough draw to pull the voltage significantly lower than root2* RMS.

I hope my camera works well enough with close ups.

This is what it looked like with two 5687 and ForePlay circuit.
regards,
Douglas

 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: supplier dealings
Next Topic: Tertiary winding OPTx windings
Goto Forum:
  


Current Time: Thu Nov 28 05:31:40 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest