AudioRoundTable.com: Group Build » Guinevere layout tips?

Home » Audio » Group Build » Guinevere layout tips?

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Guinevere layout tips? [message #30487]

Sat, 12 February 2005 10:09

colinhester
Messages: 1349
Registered: May 2009
Location: NE Arkansas

Illuminati (3rd Degree)

I'm starting to put things in place (now I know why they call it stuffing) are there any other tips to on placing components. Earlier it was mentioned that the DM2540s should be at right angles, which I've done. The Tx's and choke arealso set at right angles to one another.

I will be using Belden 8450 (2 conductor shielded w/drain) as much as possible for signal and power path. Heaters will be wired with silver-plated copper wire with Teflon insulation. I will mimick Bottlehead's SEX kit as much as possible for the appropriate wiring choice.

What about grounding the Tx and choke frames to earth? Also, the tube sockets I'm using have a center pen for ground. Should this go to earth as well?

Any and all suggestions are more than welcome......Colin

Report message to a moderator

[Message index]

		Guinevere layout tips? By: colinhester on Sat, 12 February 2005 10:09
		Re: Guinevere layout tips? By: Forty2wo on Sat, 12 February 2005 11:36
		Re: Guinevere layout tips? By: Forty2wo on Sat, 12 February 2005 14:36
		Re: Guinevere layout tips? By: PakProtector on Mon, 14 February 2005 21:07
		Re: Guinevere layout tip, Cap mounting By: Forty2wo on Sat, 12 February 2005 12:05
		Re: Guinevere layout tip, Cap mounting By: PakProtector on Sun, 13 February 2005 14:54

Previous Topic:	Ground scheme
Next Topic:	Guinevere Schematic links

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Nov 29 02:35:52 CST 2024