AudioRoundTable.com: Group Build » Heater PS schematic

Home » Audio » Group Build » Heater PS schematic

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Different values than PSU simulation [message #30370 is a reply to message #30369]

Wed, 02 February 2005 16:11

colinhester
Messages: 1349
Registered: May 2009
Location: NE Arkansas

Illuminati (3rd Degree)

There is a lot of ripple in the RCRC when compared to the choke load (LCRC.) Actually, it was pretty impressive what the choke did to flatten the voltage out.

The 5 and 3 ohm values were what was stated in T's first post regarding the heater supply, so I know where they came from.....Colin

Report message to a moderator

[Message index]

		Heater PS schematic By: Damir on Wed, 02 February 2005 15:06
		Re: Heater PS schematic By: Manualblock on Wed, 02 February 2005 15:12
		Re: Heater PS schematic By: Damir on Wed, 02 February 2005 15:23
		Re: Heater PS schematic some more By: Damir on Wed, 02 February 2005 15:14
		Different values than PSU simulation By: colinhester on Wed, 02 February 2005 15:31
		Re: Different values than PSU simulation By: Damir on Wed, 02 February 2005 15:45
		Re: Different values than PSU simulation By: colinhester on Wed, 02 February 2005 16:11
		they were a guess By: PakProtector on Wed, 02 February 2005 16:27
		Re: they were a guess By: colinhester on Wed, 02 February 2005 16:43
		Re: Different values than PSU simulation By: Manualblock on Wed, 02 February 2005 19:04

Previous Topic:	LED values?
Next Topic:	Stoetkit arrived!

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Dec 04 09:08:58 CST 2024