AudioRoundTable.com: Craftsmen

Home » Audio » Craftsmen » Trimming veneer

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Trimming veneer [message #29914 is a reply to message #29913]

Wed, 19 September 2007 20:09

colinhester
Messages: 1349
Registered: May 2009
Location: NE Arkansas

Illuminati (3rd Degree)

Bob, Sorry for the delay. Thanks for answering. I've done 4 small cabs using technique #1. The results were pretty good, but very time intensive. I was just hoping to find a way to speed the process up a bit, but it looks like I rally can't......C

Report message to a moderator

[Message index]

		Trimming veneer By: colinhester on Tue, 11 September 2007 08:29
		Re: Trimming veneer By: Bob Brines on Tue, 11 September 2007 16:56
		Re: Trimming veneer By: colinhester on Wed, 19 September 2007 20:09
		Re: Downshear flush trim bit By: Bill Epstein on Sun, 23 September 2007 11:53
		Re: Downshear flush trim bit By: DaBase on Wed, 24 February 2010 22:03

Previous Topic:	Nitrocellulose
Next Topic:	Need to find a cabinet refinisher

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Nov 28 06:37:34 CST 2024