Home » Audio » Craftsmen » Solid State vs Vacuum Tube Finish
Re: Solid State vs Vacuum Tube Finish [message #29598 is a reply to message #29594] Sat, 10 September 2005 20:51 Go to previous messageGo to previous message
Bill Martinelli is currently offline  Bill Martinelli
Messages: 677
Registered: May 2009
Illuminati (1st Degree)
You should give Varnish a try some time.
You can use tung oil and let it cure for a few days, then use 3 coats of varnish. make sure to sand between coats because varnish will not burn in like a lacquer.

 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: PI four enclosure
Next Topic: Tuba18 Sub
Goto Forum:
  


Current Time: Mon Nov 25 16:59:56 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest