AudioRoundTable.com: Craftsmen » Using Hole Saw w/o Center Bit

Home » Audio » Craftsmen » Using Hole Saw w/o Center Bit

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Yes that's my Bugle knob [message #29423 is a reply to message #29421]

Wed, 16 March 2005 20:57

Bill Martinelli
Messages: 677
Registered: May 2009

Illuminati (1st Degree)

You can have good luck using a hole saw with noe center drill if you pre drill a hole with 'that hole saw' and clamp on the top of the new part you want to drill. The top guide wood should be 1/2 - 3/4 thick and clamped firmly onto the new piece to cut.

A drill press is important for this type of work.

using a hole saw with no center drill is hospital visit waiting to happen!

Bill

Report message to a moderator

[Message index]

		Using Hole Saw w/o Center Bit By: GarMan on Tue, 15 March 2005 07:37
		Re: Yes that's my Bugle knob By: BillEpstein on Tue, 15 March 2005 11:25
		Re: Yes that's my Bugle knob By: GarMan on Tue, 15 March 2005 11:53
		Re: Yes that's my Bugle knob By: Bill Martinelli on Wed, 16 March 2005 20:57
		Re: Sissy - Mary's!!! By: Lefty on Thu, 17 March 2005 04:21
		Re: Sissy - Mary's!!! By: GarMan on Thu, 17 March 2005 11:25

Previous Topic:	I made the mistake of hooking this up
Next Topic:	Need Options for Router Table

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Aug 29 18:13:42 CDT 2024