AudioRoundTable.com: Craftsmen » Need Options for Router Table

Home » Audio » Craftsmen » Need Options for Router Table

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: I would just add: [message #29378 is a reply to message #29369]

Fri, 21 January 2005 20:16

Bill Fitzmaurice
Messages: 335
Registered: May 2009

Grand Master

My table is mounted on my table saw. I took out the metal wings on one side and replaced them with 3/4" baltic birch, drilled out to hold the router. This way it's handy but not taking up floor or counter space, and I can use the table saw rip fence and fence accessories with it. I also cut a 3/4" groove into the birch to accept the table saw miter gauge.

Report message to a moderator

[Message index]

		Need Options for Router Table By: GarMan on Wed, 12 January 2005 15:01
		Re: Need Options for Router Table By: Challanged bySound on Wed, 12 January 2005 21:56
		Re: I would just add: By: BillEpstein on Thu, 13 January 2005 03:29
		Re: I would just add: By: Bill Fitzmaurice on Fri, 21 January 2005 20:16
		Cool Idea!! (nt) By: Dean Kukral on Thu, 17 March 2005 17:29
		Re: Need Options for Router Table By: elektratig on Thu, 13 January 2005 04:42
		Thanks guys ... By: GarMan on Fri, 14 January 2005 09:07
		Re: Need Options for Router Table By: colinhester on Thu, 20 January 2005 15:25
		Re: Need Options for Router Table By: GarMan on Mon, 24 January 2005 08:50

Previous Topic:	Using Hole Saw w/o Center Bit
Next Topic:	Hard looking joinery made easy

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Nov 07 05:25:16 CST 2024