Staining problem [message #29375] |
Fri, 21 January 2005 10:07 ![Go to next message Go to next message](/forum/theme/AudioRoundTable/images/down.png) |
Bill Wassilak
Messages: 402 Registered: May 2009
|
Illuminati (1st Degree) |
|
|
I stained some panels on some speakers I'm building using minwax provisional stain. Well one of the panels came out to dark. Is there a way with say a rag with paint thinner or something to lighten it up with out having to take and sand it all the way down. Thanks Bill W.
|
|
|
|
Re: Staining problem [message #29377 is a reply to message #29375] |
Fri, 21 January 2005 15:26 ![Go to previous message Go to previous message](/forum/theme/AudioRoundTable/images/up.png) |
BillEpstein
Messages: 886 Registered: May 2009
|
Illuminati (2nd Degree) |
|
|
Welllll...you have a couple of problems. It's fairly easy to lighten the panel with bleaching kits sold at paint stores but then it's hit and miss to get the same color density as the other panel. You can also put shellac over the stain and then use a honey amber or other dye stain to lighten the color. It's probably best to do both. Use a bit of the bleaching agent in a corner to try to find the right solution to lighten the color the proper amount. Then put a coat of blonde shellac on both panels and apply a water-based dye stain over it to get the color you want. If you have a Woodcraft or Rocklers, etc nearby there is always someone knowledgeable and eager to guide you through the toning process. Don't give up and reach for the sander. You won't believe how deep the stain went into the Pine and you will probably create a lot of low and high spots. Let us know how it turns out.
|
|
|