AudioRoundTable.com: Craftsmen » Need Options for Router Table

Home » Audio » Craftsmen » Need Options for Router Table

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: I would just add: [message #29369 is a reply to message #29367]

Thu, 13 January 2005 03:29

BillEpstein
Messages: 886
Registered: May 2009

Illuminati (2nd Degree)

When you need a short piece of trim push a longer piece thru the bit and then remove it from the table once you get to the length you need. Your hands never go past the bit.
Drill an 1/8" hole in the table near the bit, place a piece of rod in it and now you have an "index pin" you use to guide the workpiece into the bit for those times when you can't use a fence.

Report message to a moderator

[Message index]

		Need Options for Router Table By: GarMan on Wed, 12 January 2005 15:01
		Re: Need Options for Router Table By: Challanged bySound on Wed, 12 January 2005 21:56
		Re: I would just add: By: BillEpstein on Thu, 13 January 2005 03:29
		Re: I would just add: By: Bill Fitzmaurice on Fri, 21 January 2005 20:16
		Cool Idea!! (nt) By: Dean Kukral on Thu, 17 March 2005 17:29
		Re: Need Options for Router Table By: elektratig on Thu, 13 January 2005 04:42
		Thanks guys ... By: GarMan on Fri, 14 January 2005 09:07
		Re: Need Options for Router Table By: colinhester on Thu, 20 January 2005 15:25
		Re: Need Options for Router Table By: GarMan on Mon, 24 January 2005 08:50

Previous Topic:	Using Hole Saw w/o Center Bit
Next Topic:	Hard looking joinery made easy

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Nov 07 07:30:11 CST 2024