AudioRoundTable.com: Craftsmen » Using a fly cutter

Home » Audio » Craftsmen » Using a fly cutter

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Using a fly cutter [message #29231]

Sat, 21 August 2004 11:05

lon
Messages: 760
Registered: May 2009

Illuminati (2nd Degree)

I just wondered if there's an answer to the question of getting
plug out of a fly cutter-- those hole saws used with a
drill press or power drill.

Only thing I thought of is boring nearly all the way through
then using the drill bit center as a guide on the reverse side,
finishing the cut so the plug doesn't get wedged in the
hole saw.

Coming up on a project for arrays, a hole saw makes the job
both easier and gives a smoother cutout.

Report message to a moderator

[Message index]

		Using a fly cutter By: lon on Sat, 21 August 2004 11:05
		Re: Using a fly cutter By: wunhuanglo on Sat, 21 August 2004 14:52
		Re: Using a fly cutter ( should be hole saw) By: lon on Sat, 21 August 2004 15:32
		Re: Using a fly cutter ( should be hole saw) By: wunhuanglo on Wed, 25 August 2004 04:57
		Re: Using a fly cutter ( should be hole saw) By: lon on Wed, 25 August 2004 11:58

Previous Topic:	Quick poll: what would you veneer with out of these?
Next Topic:	Other plywood tricks

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Mon Nov 25 06:12:35 CST 2024