AudioRoundTable.com: Home Theater » in-wall volume control 1 input into 2 speakers

Home » Audio » Home Theater » in-wall volume control 1 input into 2 speakers

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

in-wall volume control 1 input into 2 speakers [message #28509]

Sat, 23 July 2005 23:42

Bpb Baker
Messages: 2
Registered: May 2009

Esquire

I recently built and new home and was able to have it pre-wired for multiroom speakers and have the speakers installed at the time. Now that I am hooking up the receiver and multiroom amp up, I have noticed that one of the cables run out to one of the outside speakers is not conducting signal. I have checked the cable going from the in-wall volume know to the speaker and it is working.

Can I run 1 input into 2 speakers? I realized I will only be getting one channel and that, I believe the resistance will drop from 8 ohms (which is the impedance of each outside speaker) to 4 ohms. Should I use an impedance matching volume control?

I do not want to tear up any of the new walls/carpet and I don't have time to do anything else. I realize this is just a stop-gap solution but can I do it?

Thanks,

Bob Baker

Report message to a moderator

[Message index]

		in-wall volume control 1 input into 2 speakers By: Bpb Baker on Sat, 23 July 2005 23:42
		Re: in-wall volume control 1 input into 2 speakers By: Wayne Parham on Sun, 24 July 2005 10:19
		Re: in-wall volume control 1 input into 2 speakers By: Bpb Baker on Sun, 24 July 2005 14:06
		Re: in-wall volume control 1 input into 2 speakers By: Wayne Parham on Sun, 24 July 2005 15:24
		Builder warranty? By: colinhester on Sun, 24 July 2005 23:39

Previous Topic:	speaker cable length for HT
Next Topic:	A couple of general Home Theater questions if I may...

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Mon Nov 18 11:09:37 CST 2024