Home » Audio » Radio » Atwater Kent Model 37
Re: Atwater Kent Model 37 [message #25674 is a reply to message #25673] Sat, 02 April 2005 04:17 Go to previous message
Bradshaw is currently offline  Bradshaw
Messages: 2
Registered: May 2009
Esquire
Wayne,

Thanks for all the good advice. I'll start looking for the new caps to put in and see if I can find some cloth bound wire too.

This radio is in a stamped metal box for a case. Some of the paint is chipping and has rusted in places. The paint has a unique "orange peel" finish to it. Do you know of any paint that is available that will give the same finished results?

We've also got an RCA Radiola 18. Picked it up about 20 years ago on someone's trash can sitting by the road. The speaker and the cabinet were painted an aweful light "pea grean". We removed the paint to expose the beautiful walnut case and painted the speaker brown. Attached an antenna and it fired right up. Its been in the attic a good while. I think part of the tuning mechanism failed, as the knob would not tune it when I last checked.

Maybe I'll tackle that when I get the Atwater Kent going.

Once again, thanks for the help.
Bradshaw

 
Read Message
Read Message
Read Message
Previous Topic: philco model 20
Next Topic: Ramco Tube Radio -- Anyone heard of one?
Goto Forum:
  


Current Time: Mon Nov 25 17:27:39 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest