Home » Audio » Speaker » MG 1 power requirements?
MG 1 power requirements? [message #24748] Thu, 11 May 2006 20:31 Go to next message
MWG is currently offline  MWG
Messages: 344
Registered: May 2009
Grand Master
The repair kit is on the way finally. So maybe I can hear them as they should sound. How much power do I need for them so I can have some headroom left for Classical & Jazz? My main amp is a Mac 2505 which is 50 WPC until I get my MC-275 fixed. I was thinking of buying a 150-200 WPC SS amp just for them. Something vintage and inexpensive. Anybody here own a pair or any Maggies? What would be your recommendations? I've had my Valencias longer than my Mac amp so never needed much power as they are pretty efficient.

Re: MG 1 power requirements? [message #24749 is a reply to message #24748] Sat, 13 May 2006 22:38 Go to previous messageGo to next message
Wayne Parham is currently offline  Wayne Parham
Messages: 18792
Registered: January 2001
Illuminati (33rd Degree)

Their sensitivity is in the mid 80's and power handling is 250 watts. I wouldn't skimp on power 'cause even at 100 watts you're just barely over 100dB.


Re: MG 1 power requirements? [message #24750 is a reply to message #24748] Mon, 15 May 2006 20:20 Go to previous messageGo to next message
colinhester is currently offline  colinhester
Messages: 1349
Registered: May 2009
Location: NE Arkansas
Illuminati (3rd Degree)
As Wayne said, sensitivity is mid 80s, but this is at 4 ohms (if memory serves me.) I think 200wpc (clean power at 4 ohms) should be about right, if you really want to rock out.

I have a pair of MMG-W, and they do just fine on a 35 wpc PP tube amp. No, they are not going to bring the house down, but they sound dead-on for small jazz ensambles and uncluttered classical.....Colin

Re: MG 1 power requirements? [message #24751 is a reply to message #24748] Tue, 16 May 2006 15:19 Go to previous messageGo to next message
jpvanson is currently offline  jpvanson
Messages: 6
Registered: May 2009
Esquire
I've a pair of MG-Is as well. Great speakers that introduced me to good audio and ultimately spoiled my taste for mediocre speakers.

The MG-I is rated at 82dB/w/m at 5 ohms input. However, the truly magnaplanar design as these are offer up a nearly resistor flat impedance curve so the 5 ohms is easier to drive tham equivalent sensitivity 8ohm speakers. Depending upon the size of your room, you can get by satisfactorily with that 50wpc amp of yours. I used a cheap 45wpc amp for a few months and found the combination very enjoyable. I've run everything from a 15wpc 6BQ5 Fisher SA-16 amp up to ~200wpc solidstate and found them to sound good regardless. However, this is in an ~15'x16' room (technically larger thanks to an L-shaped design).

If you room is a great deal larger then definitely look for a high-current amplifier more than the watts. Maggies respond more to current than other speakers and you will appreciate the results.

Good luck.
- JP

Re: MG 1 power requirements? [message #24752 is a reply to message #24751] Tue, 16 May 2006 15:23 Go to previous messageGo to next message
jpvanson is currently offline  jpvanson
Messages: 6
Registered: May 2009
Esquire
If I may ... here's the MG-I brochure containing some of the technical specifications if you're interested.

- JP

Re: MG 1 power requirements? [message #24753 is a reply to message #24749] Tue, 16 May 2006 20:36 Go to previous message
MWG is currently offline  MWG
Messages: 344
Registered: May 2009
Grand Master
Thank you guys for all your input. I was asleep at the wheel and forgot to respond.

I found a Yamaha M-50 @ 120 WPC@ 8 Ohms and supposedly 200 @ 4 )hms so at 5-6 Ohms I should be in there

My room (snicker here ) is my sometimes shop which is 22' X 18'. It's full of stuff and I put a cheap carpet on the floor in front of the speakers and carpet on the wall behind the speakers & gear. It looks a little funky but it knocks down some of the standing waves.

Once again thanks for your input. I got an e-mail saying the kit is on the way so shortly I should hear them as they should sound. I'll order new socks if it turns out well.

Previous Topic: Need advice on cabinet choice for JBL E120
Next Topic: Using Car Speakers With Your Hi Fi
Goto Forum:
  


Current Time: Wed Dec 04 15:03:45 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest