Home » Audio » Speaker » Acoustat 1+1 bias voltage idea
Acoustat 1+1 bias voltage idea [message #24736] Wed, 28 September 2005 08:34 Go to previous message
morricab is currently offline  morricab
Messages: 2
Registered: May 2009
Esquire
Hi,
I am a scientist that is used to working with commercial high voltage power supplies (up to 30KV). I have found several manufacurers who sell power supplies in that are variable between 0-5KV to 0-10KV. What is interesting about them is the stability specifications like very low ripple and tight voltage regulation. Since the amount of actual current placed on the panels is minimal (I calculated about 10 microamps with the 500Mohm resistor at 5KV) then the lowest cost supplies are an option. I would think that this should outperform any of the mods to the conventional power supply but they are kind of expensive if I remember correctly (a pair might run $1000). Interested in your feedback.


 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: RE: mounting woofer
Next Topic: Mounting Woofer
Goto Forum:
  


Current Time: Sat Jun 15 21:19:55 CDT 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest