Home » Audio » Speaker » ESL Bias Supply Filtering Update
Re: ESL Bias Supply Filtering Update CORRECTION [message #24728 is a reply to message #24725] Wed, 03 August 2005 08:18 Go to previous message
moray james is currently offline  moray james
Messages: 51
Registered: May 2009
Baron
I got the new ten section ten Henry chokes built and cryo treated. I installed them and was able to compare the sound to that of the two Hammond seven Henry chokes which had been in series for a total of fourteen Henries. The new ten Henry chokes sound better. They are built up from ten one Henry chokes connected in series and physically spaced. Each choke is mounted at right angles to the next in a line. The chokes were bought from surplus and were very inexpensive. Remember that the choke goes in series with the high voltage output after the load resistor and before the diaphragm. Give this mod a try and I am sure that you will be very pleased with the results. Best regards Moray James.

 
Read Message
Read Message
Read Message
Read Message
Previous Topic: EV TL5050/Sentry IV horns--any good?
Next Topic: Can single driver speaker rock?
Goto Forum:
  


Current Time: Thu Nov 28 16:58:31 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest